MIL-DTL-81997D
AMERICAN SOCIETY FOR QUALITY (ASQ)
ASQC-Z1.4
-
Procedures, Sampling and Tables for Inspection by
Attributes. (DoD adopted)
(Copies of this document are available from https://www.asq.org or the American Society for
Quality, 600 North Plankinton Avenue, Milwaukee, WI 53203.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein, the text of this document takes precedence. Nothing in this document,
however, supersedes applicable laws and regulations unless a specific exemption has been
obtained.
3. REQUIREMENTS
3.1 First article. When specified (see 6.2), samples shall be subjected to first article
inspection in accordance with 4.2.
3.2 Materials.
3.2.1 Type I. Cushioning material conforming to PPP-C-795, class 2 (thin thickness), and
barrier material conforming to MIL-PRF-81705, Type III, shall be used.
3.2.2 Type II. Cushioning material conforming to PPP-C-795, class 2 (thin thickness), shall
be used.
3.3 Construction.
3.3.1 Type I. Type I pouches shall be formed by placing together 1 sheet of barrier material
(heat-sealable side shall face cushioning material) and 1 sheet of cushioning material (cushioning
medium shall face heat-sealable side of barrier material smooth side of cushioning material
shall become the innermost surface of pouch), then folding both in half, heat seal along both
sides.
3.3.1.1 Closure (Type I). The open end or top edge of type I pouches shall be provided with
a reclosable zipper-type interlocking closure. The closure shall be effected by two strips a rib
element on one side of the pouch and a complementary groove element on the other side that
shall be heat sealed to the pouch. The zipper so formed shall be closable by applying finger
pressure. The strips shall have a flange a minimum of 1/2 inch in width extending above the
zipper closure. A colored line, approximately 1/4 inch above and parallel to the zipper track,
shall be marked to indicate where the flange shall be pulled to open the zipper. The closure
material shall be electrostatic protective and meet all the requirements of MIL-PRF-81705,
type II.
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business