MIL-DTL-6060E
3.8 Inspection windows. Unless otherwise specified, inspection windows shall conform to
the requirements of 3.8.1 through 3.8.3.
3.8.1 Window material. Inspection windows shall be constructed of material conforming to
MIL-PRF-22191, type I.
3.8.2 Window dimensions. Unless otherwise specified, for bags having both outside length
and width dimensions greater than 36 inches, the window shall be 4 inches by 8 inches and the
window material shall be 6 inches by 10 inches. For smaller bags, the window shall be 2 inches
by 4 inches using window material 4 inches by 6 inches.
3.8.3 Mounting of window. The window material shall be centered under the window
aperture in the barrier material and completely heat-sealed in place. The heat-seal shall form a
continuous bond that meets the requirements of 4.4.3.
3.9 Gaskets.
3.9.1 Gasket material. Gaskets shall have a nominal thickness of 0.062 ± 0.010 inch and
shall be made of any resilient material that forms a seal and meets the requirements of 4.4.4. The
shape and size of the gaskets shall be as specified in the contract or purchase order.
3.9.1.1 Gasket adhesive. A water-resistant adhesive shall be used for mounting the gaskets
to the barrier material.
3.9.2 Gasket mounting. Gaskets shall be attached to the inside and outside of the envelope,
shall coincide with their paired members, and shall not be positioned within 1 inch of the inside
line of any seam. The gaskets shall be mounted at points indicated on the packaging instructions.
No holes shall be punched in the barrier material for the hold down bolts unless specified in the
contract or packaging instructions.
3.10 Workmanship. Bags shall be free from any foreign matter, holes, tears, cuts, sharp
creases, wrinkles, or other imperfections.
3.11 Performance requirements. The bags shall meet the requirements specified in table I
when tested in accordance with 4.4.
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business